the following is an introduction to the inspection of wood drying equipment entering the kiln.
1. ground, drying room ground should be kept clean and tidy, after a drying cycle should be timely cleaning of debris.
2. ventilation system, check whether the fastening bolt is loose, whether the fan runs smoothly and freely, whether the clearance between the blade and the hood is uniform, whether the bearings of motor and other parts are worn, whether the grease is lost, whether the cable is aging, etc.
3. shell, the key point is to check the insulation and air tightness of the shell.
4. gates, after long-term use, may leak due to deformation, corrosion, aging seal or failure of compression device. if such a situation is found, it should be repaired in time.
5. instruments, check whether the water in the tank of dry-wet bulb thermometer is clean, gauze is clean and wet, check the temperature sensor and moisture sensor and instrument regularly, check their sensitivity and reliability.
6. heating system, after 15 minutes of hot water, check whether the heater heating is uniform, whether the whole system has leakage, whether the circulating pump is working properly.
7. humidity control system, check whether the sprinkler holes are smooth and even, whether the intake and exhaust switches are flexible and reliable, and whether they are tight after closing.
the above is about the inspection of wood drying equipment entering kiln. i hope it will be helpful to you. for more information, please log in at www.baoyangganzao.com.